Back to opcode table

CLAC—Clear AC Flag in EFLAGS Register

Opcode Instruction Op/En 64-bit Mode Compat/Leg Mode Description
0F 01 CA CLAC NP Valid Valid Clear the AC flag in the EFLAGS register.

Instruction Operand Encoding

Op/En Operand 1 Operand 2 Operand 3 Operand 4
NP NA NA NA NA

Description

Clears the AC flag bit in EFLAGS register. This disables any alignment checking of user-mode data accesses. If the SMAP bit is set in the CR4 register, this disallows explicit supervisor-mode data accesses to user-mode pages.

This instruction's operation is the same in non-64-bit modes and 64-bit mode. Attempts to execute CLAC when CPL > 0 cause #UD.

Operation

EFLAGS.AC ← 0;

Flags Affected

AC cleared. Other flags are unaffected.

Protected Mode Exceptions

#UD

If the LOCK prefix is used.

If the CPL > 0.

If CPUID.(EAX=07H, ECX=0H):EBX.SMAP[bit 20] = 0.

Real-Address Mode Exceptions

#UD

If the LOCK prefix is used.

If CPUID.(EAX=07H, ECX=0H):EBX.SMAP[bit 20] = 0.

Virtual-8086 Mode Exceptions

#UD The CLAC instruction is not recognized in virtual-8086 mode.

Compatibility Mode Exceptions

#UD

If the LOCK prefix is used.

If the CPL > 0.

If CPUID.(EAX=07H, ECX=0H):EBX.SMAP[bit 20] = 0.

64-Bit Mode Exceptions

#UD

If the LOCK prefix is used.

If the CPL > 0.

If CPUID.(EAX=07H, ECX=0H):EBX.SMAP[bit 20] = 0.